The crib is where your baby will spend a lot of their time, and you want to be sure they're safe. Below are some of the questions (with the answers) that are asked about crib safety. Topics such as mattress position, the way to put your baby in the crib, and general safety standards are discussed, as are other problems. If you require further information, you can search the Internet and visit baby furniture stores.
Q. Are there any safety standards for baby cribs?
There are some very precise standards for your baby's crib. It was made a law that cribs shouldn't longer be painted with lead-based paint. It had been discovered that the ingestion of lead (from any source) could cause learning disabilities and other issues in young children. The slats of the crib have to be no greater than 2 3/8 inches apart; this is to prevent your baby from becoming his body or head stuck between the bars causing harm or strangulation. The sidebar should be 26 inches above the mattress if it is in its lowest position. If your kid is more than an inch taller than the sidebar, now is the time to move him into a standard bed.
Q. Are there some hazards in my baby's crib I want to know about?
Your mattress should fit snugly in the crib; an ill-fitting mattress could cause your baby to slip between the mattress and the sidebar, causing suffocation. The mattress height should be able to be adjusted to at least three levels. If your baby becomes more mobile, you will want to set the mattress in the lowest place to stop your baby from climbing or falling out. The slats should be tight; loose slats can pinch little fingers. Don't set the crib near a window to prevent your baby from falling out or getting tangled in Venetian blind cords.
Q. What are some historical facts about the crib?
Here is a brief timeline of crib facts:
1973 – The standard for infant crib slats was to be no longer than two 3/8th inches apart to prevent your baby from slipping through or getting their head. Also, double-sided for sidebars that are drop-down were to become the standard.
1976 – The standard for cutouts in the end panels have been presented. The end panels must not have any decorative cutout designs. Kids were getting their limbs or heads captured, causing death or harm.
1978 – Cribs must be painted with the non-toxic end.
1981 – Two models of Automobiles with cutouts are recalled.
1988 – A voluntary standard addresses mattress support hardware, failure of glued or wired connections, failure, and loosened teething rails.
1990 – No corner posts or projections can be more than 1/16th of an inch over the drop-side.
1998 – California and Washington mandate that hotel stalls must meet the standards
Set for full-size cribs
1998 – Portable cribs must meet the same standards as full-sized cribs.
Q. How can I tell if my baby is ready for a bed?
When your child stands more than a few inches taller than the faucet, if your child is climbing out of the crib, for his safety, put him in a bed.
Q. Should I put my baby to sleep in his crib?
Place your baby on his back or on his side for sleeping. Use one-piece sleepers rather than blankets. Your baby could slip under the blanket and possibly suffocate. Remove all pillows and toys also, so as to avoid suffocation.
Q. Is it safe to pay my baby with a blanket?
A blanket will help keep your baby warm when sleeping. If you need to use a blanket, tuck it in around the base of the mattress. Put your baby with his toes toward the end-panel, and the blanket must go no greater than his/her chest.
Q. Is a net sided crib safe to use for the baby?
Yes, a mesh crib is safe provided the net is less than 1/4 inch in size, smaller than a very small button on baby's clothing. The ought to be rips, tears, or loose threads. If staples are used to attach the net, they shouldn't be exposed, and the mesh must be securely attached to the top rail and the ground plate.
Q. Can I safely use bumper pads in my baby's crib?
They can be used, while bumper pads are not necessary. They need to be near the edge of the mattress and properly secured. The bumpers have to be flat and not puffy, as the baby might get stuck between the bumper and the mattress and suffocate.
Q. What can I do to maintain my baby's crib secure?
In order to maintain your baby's safe location, you should make certain to all connections are secure and that there are no broken or missing components. Regularly assess the teething rail for splits or cracks. Ensure that the spring support and your crib will withstand your baby's growing mobility. The mattress needs to have no splits, tears, or openings.
Q. How can I tell when it's time?
If your baby becomes more active, when he begins to pull himself to a standing position or when he sits up alone, it will be time to lower the mattress to prevent your little one.
Q. Can I hang a cellphone over my baby's crib?
Mobiles and crib gyms can be used to entertain your baby; however, when your child can get on to their hands and knees or pull themselves up. This will stop your baby from becoming entangled in them.
Ensuring your baby's crib is safe, is an ongoing to action. Proper positioning of the mattress, making certain all connections are secure, and there aren't any loose slats that could pinch little fingers will help to maintain your baby's crib a secure place for him to be.
Be sure to place him and dress him in a sleeper instead of having a blanket. Keeping these ideas in mind can help keep your baby safe and give you some reassurance. If you want to read more about convertible cribs and cribs in general then be sure to check Cerro Reyes.